INCANDESCENT REFLECTOR LAMP EFFICIENCY STANDARDS.

SEC. 322. INCANDESCENT REFLECTOR LAMP EFFICIENCY STANDARDS.(a) Definitions.—Section 321 of the Energy Policy and Conservation Act (42 U.S.C. 6291) (as amended by section 316(c)(1)(D)) is amended—(1) in paragraph (30)(C)(ii)—(A) in the matter preceding subclause (I)—(i) by striking “or similar bulb shapes (excluding ER or BR)” and inserting “ER, BR, BPAR, or similar bulb shapes”; and(ii) by striking “2.75” and inserting “2.25”; and(B) by striking “is either—” and all that follows through subclause (II) and inserting “has a rated wattage that is 40 watts or higher”; and(2) by adding at the end the following:“(54) BPAR incandescent reflector lamp.—The term ‘BPAR incandescent reflector lamp’ means a reflector lamp as shown in figure C78.21–278 on page 32 of ANSI C78.21–2003.“(55) BR incandescent reflector lamp; br30; br40.—“(A) BR incandescent reflector lamp.—The term ‘BR incandescent reflector lamp’ means a reflector lamp that has—“(i) a bulged section below the major diameter of the bulb and above the approximate baseline of the bulb, as shown in figure 1 (RB) on page 7 of ANSI C79.1–1994, incorporated by reference in section 430.22 of title 10, Code of Federal Regulations (as in effect on the date of enactment of this paragraph); and121 STAT. 1588“(ii) a finished size and shape shown in ANSI C78.21–1989, including the referenced reflective characteristics in part 7 of ANSI C78.21–1989, incorporated by reference in section 430.22 of title 10, Code of Federal Regulations (as in effect on the date of enactment of this paragraph).“(B) BR30.—The term ‘BR30’ means a BR incandescent reflector lamp with a diameter of 30/8ths of an inch.“(C) BR40.—The term ‘BR40’ means a BR incandescent reflector lamp with a diameter of 40/8ths of an inch.“(56) ER incandescent reflector lamp; er30; er40.—“(A) ER incandescent reflector lamp.—The term ‘ER incandescent reflector lamp’ means a reflector lamp that has—“(i) an elliptical section below the major diameter of the bulb and above the approximate baseline of the bulb, as shown in figure 1 (RE) on page 7 of ANSI C79.1–1994, incorporated by reference in section 430.22 of title 10, Code of Federal Regulations (as in effect on the date of enactment of this paragraph); and“(ii) a finished size and shape shown in ANSI C78.21–1989, incorporated by reference in section 430.22 of title 10, Code of Federal Regulations (as in effect on the date of enactment of this paragraph).“(B) ER30.—The term ‘ER30’ means an ER incandescent reflector lamp with a diameter of 30/8ths of an inch.“(C) ER40.—The term ‘ER40’ means an ER incandescent reflector lamp with a diameter of 40/8ths of an inch.“(57) R20 incandescent reflector lamp.—The term ‘R20 incandescent reflector lamp’ means a reflector lamp that has a face diameter of approximately 2.5 inches, as shown in figure 1(R) on page 7 of ANSI C79.1–1994.”.(b) Standards for Fluorescent Lamps and Incandescent Reflector Lamps.—Section 325(i) of the Energy Policy and Conservation Act (42 U.S.C. 6995(i)) is amended by striking paragraph (1) and inserting the following:“(1) Standards.—“(A) Definition of effective date.—In this paragraph (other than subparagraph (D)), the term ‘effective date’ means, with respect to each type of lamp specified in a table contained in subparagraph (B), the last day of the period of months corresponding to that type of lamp (as specified in the table) that follows October 24, 1992.“(B) Minimum standards.—Each of the following general service fluorescent lamps and incandescent reflector lamps manufactured after the effective date specified in the tables contained in this paragraph shall meet or exceed the following lamp efficacy and CRI standards:“FLUORESCENT LAMPS Lamp TypeNominal Lamp WattageMinimum CRIMinimum Average Lamp Efficacy (LPW)Effective Date (Period of Months) 4-foot medium bi-pin>35 W6975.036 ≤35 W4575.036121 STAT. 1589 2-foot U-shaped>35 W6968.036 ≤35 W4564.036 8-foot slimline 65 W6980.018 ≤65 W4580.018 8-foot high output>100 W6980.018 ≤100 W4580.018 “INCANDESCENT REFLECTOR LAMPS Nominal Lamp WattageMinimum Average Lamp Efficacy (LPW)Effective Date (Period of Months) 40–5010.536 51–6611.036 67–8512.536 86–11514.036 116–15514.536 156–20515.036 “(C) Exemptions.—The standards specified in subparagraph (B) shall not apply to the following types of incandescent reflector lamps:“(i) Lamps rated at 50 watts or less that are ER30, BR30, BR40, or ER40 lamps.“(ii) Lamps rated at 65 watts that are BR30, BR40, or ER40 lamps.“(iii) R20 incandescent reflector lamps rated 45 watts or less.“(D) Effective dates.—“(i) ER, br, and bpar lamps.—The standards specified in subparagraph (B) shall apply with respect to ER incandescent reflector lamps, BR incandescent reflector lamps, BPAR incandescent reflector lamps, and similar bulb shapes on and after January 1, 2008.“(ii) Lamps between 2.25–2.75 inches in diameter.—The standards specified in subparagraph (B) shall apply with respect to incandescent reflector lamps with a diameter of more than 2.25 inches, but not more than 2.75 inches, on and after the later of January 1, 2008, or the date that is 180 days after the date of enactment of the Energy Independence and Security Act of 2007.”.