DEVELOPMENT OF STRATEGY ON RISKS TO NONPROLIFERATION CAUSED BY ADDITIVE MANUFACTURING.

SEC. 3139. [50 U.S.C. 2367 note] DEVELOPMENT OF STRATEGY ON RISKS TO NONPROLIFERATION CAUSED BY ADDITIVE MANUFACTURING. (a) Strategy.—The President shall develop and pursue a strategy to address the risks to the goals and policies of the United States regarding nuclear nonproliferation that are caused by the increased use of additive manufacture technology (commonly referred to as “3D printing”), including such technology that does not originate in the United States. (b) Briefings.— (1) In general.—Not later than March 31, 2016, and annually thereafter through 2019, the President shall provide to the appropriate congressional committees a briefing on the strategy developed under subsection (a). (2) Interim briefings.—In addition to the briefings required by paragraph (1), the President shall provide to the appropriate congressional committees a notification or briefing if there is a development in additive manufacture technology, or increased use of additive manufacture technology, that could pose an increased risk to the United States from nuclear proliferation. (c) Pursuit of Strategy.—The President shall pursue the strategy developed under subsection (a) at the Nuclear Security Summit in Chicago, Illinois, in 2016. (d) Appropriate Congressional Committees Defined.—In this section, the term “appropriate congressional committees” means the following: (1) The congressional defense committees. (2) The Permanent Select Committee on Intelligence of the House of Representatives and the Select Committee on Intelligence of the Senate. (3) The Committee on Foreign Affairs of the House of Representatives and the Committee on Foreign Relations of the Senate.