Glider Kits

01. Title Application Requirements. (3-21-22) a. An MCO for the glider kit will be submitted with the application for title. (3-21-22) b. If the applicant dismantles a vehicle presently titled to the applicant and uses the significant parts with the glider kit, either a statement of fact will be prepared or the applicant will complete an affidavit, identifying the significant parts by identifying numbers. If the significant parts were purchased separately from a new or used parts outlet, a bill of sale or invoice is necessary. If the significant parts were purchased from a private owner, a bill of sale is necessary. (3-21-22) c. If the frame and cab that the parts were stripped from will never be used again, i.e., frame and cab destroyed, not salvageable, the title will be surrendered with the application. If the frame or cab can be used again, the owner or motor vehicle investigator will mark the title “frame only” or “cab only.” (3-21-22) d. The vehicle will be completely assembled and meet the requirements of Chapter 9, Title 49, Idaho Code, and the federal motor vehicle safety standards in effect for the model year at the time of application. (3-21-22) 02. Assignment of VIN. The VIN will be the number assigned to the kit by the manufacturer. In the absence of such number, the motor vehicle investigator will assign a VIN. (3-21-22) 03. Model Year. The model year will be the year of the kit, determined by priority in the following order: (3-21-22) a. Written statement from the manufacturer. (3-21-22) IDAHO ADMINISTRATIVE CODE IDAPA 39.02.05 Idaho Transportation Department Issuance of Certificates of Title Section 305 Page 11 b. Seventeen (17) character VIN’s model year designator; (3-21-22) c. Designation of model year shown on an approved MCO; or (3-21-22) 04. Make of Vehicle. The make of the vehicle will be the make of the glider kit. (3-21-22) 05. Title Branded. The designation “GLIDER KIT VEHICLE” will be branded on the title. (3-21-22) 305. TITLE APPLICATION REQUIREMENTS FOR REPLICA, STREET RODS, REPLICA STREET RODS, AND ASSEMBLED VEHICLES. 01. Applicant Will Provide Proof of Ownership. The applicant will provide proof of ownership for all significant parts that are used in replicating or assembling the vehicle. The body will have a properly released title from the previous owner or a title in the applicant’s name. The frame only may be transferred with a copy of a bill of sale given by the legal owner showing the vehicle identification number (VIN). Other significant parts that are used will be verified by traceable invoices identifying the significant part or parts if purchased from an established new or used parts outlet. If the other significant parts are purchased from a private party, a bill of sale showing the seller’s name and address is necessary. An MCO will accompany the documents for manufactured kits or if no MCO was issued, a factory invoice or bill of sale from the selling dealer together with a statement certifying no MCO was issued for the kit is acceptable. (3-21-22) 02. Model Year. The model year for replica vehicles and replica street rods will be the year that the vehicle replicates. The model year for assembled vehicles and street rods will be the model year of the vehicle body. (3-21-22) 03. Inspection by a Motor Vehicle Investigator. When the vehicle is in operating condition an inspection by a motor vehicle investigator is necessary. A fee of twenty-five dollars ($25) is necessary for this inspection and the preparation of the statement of fact and indemnifying statement. In addition, if a vehicle identification number is assigned, the fee in Section 49-202(2)(j), Idaho Code, will be charged. If the vehicle is eligible to be registered for road use, the owner will complete a self-certification form prescribed by the Department stating that the vehicle is in compliance with Chapter 9, Title 49, Idaho Code, and meets the federal motor vehicle safety and emission standards in effect for the model year and type of vehicle. (3-21-22) 306. -- 399. (RESERVED)