35 Ill. Adm. Code 283.130
Definitions
Section 283
Section 283.130 Definitions
Unless otherwise defined in this
Section or unless a different meaning of a term is clear from its context, the
definitions of terms used in this Part shall have the meanings specified by 35
Ill. Adm. Code 201.102 and 35 Ill. Adm. Code 211.
"Agency" means the Illinois Environmental
Protection Agency.
"Continuous steady-state unit" means an emission
unit that, as an inherent result of its design or operation, produces a
steady-state emissions stream.
"Cyclic steady-state unit" means an emission unit
that operates on a batch basis and that exhibits uniform operating parameters
and produces similar emissions from batch to batch, and has a batch cycle time
such that it is practical to perform a single test run during one or more whole
batch cycles.
"Minor deviation" means a change to a test plan
that does not affect the stringency of the emission limitation or standard
(i.e., no emission limit or standard relaxation); and has no national
significance (i.e., the change will not affect the applicable regulation's
implementation for other sources in the affected category); and is
site-specific (the applicability of the change is determined only for the
source at issue). A minor deviation includes, but is not limited to, the
following: a modified sampling traverse (the procedure of measuring gas
velocity at specific points across the cross sectional area of a stack for the
purpose of determining the gas velocity profile) or location to avoid
interference from an obstruction in the stack; increasing the sampling time or
volume; use of additional impingers for a high moisture situation; accepting
particulate emission results for a test run that was conducted with a lower
than specified temperature; substitution of a material in the sampling train
that has been demonstrated to be more inert for the sampling matrix; and
changes in recovery and analytical techniques such as a change in quality
control/quality assurance requirements needed to adjust for analysis of a
certain sample matrix.
"Qualifying unit" means an emission unit that
during normal operating conditions produces a consistent pattern of emissions.
"Valid test run" means a completed test run,
conducted in accordance with a test plan submitted to the Agency, as required
under Section 283.220 of this Part, or a test plan modified in accordance with
Section 283.230 of this Part.