35 Ill. Adm. Code 722.115
Satellite Accumulation Area Regulations for a Small Quantity Generator or Large Quantity Generator
Section
722.115
Satellite Accumulation Area Regulations for a Small Quantity Generator or Large
Quantity Generator
a) A generator may accumulate as
much as 55 gallons (208 ℓ) of non-acute hazardous waste or either one
quart (0.94 ℓ) of liquid acute hazardous waste listed in 35 Ill. Adm.
Code 721.131 or 721.133(e) or 1 kg (2.2 lbs) of solid acute hazardous waste
listed in 35 Ill. Adm. Code 721.131 or 721.133(e) in containers at or near any
point of generation where wastes initially accumulate that is under the control
of the operator of the process generating the waste, without a permit or
interim status and without complying with the requirements of 35 Ill. Adm. Code
702, 703, 705, and 724 through 727, provided that the generator complies with
all of the conditions for exemption in this Section. A generator may comply
with the conditions for exemption in this Section instead of complying with the
conditions for exemption in Section 722.116(b) or 722.117(a), except as
required in Section 722.115(a)(7) and (a)(8). The conditions for exemption for
satellite accumulation are the following:
1) If a container holding
hazardous waste is not in good condition, or if the container begins to leak,
the generator must immediately transfer the hazardous waste from the leaking
container to a container that is in good condition and not leaking, or
immediately transfer and manage the waste in a central accumulation area
operated in compliance with Section 722.116(b) or 722.117(a).
2) The generator must use a
container made of or lined with materials that will not react with and that are
otherwise compatible with the hazardous waste to be accumulated, so that the
ability of the container to contain the waste is not impaired.
3) Special Standards for
Incompatible Wastes
A) The generator must not place
incompatible wastes or incompatible wastes and materials (see appendix V of 40
C.F.R. 265, incorporated by reference in 35 Ill. Adm. Code 720.111, for
examples) in the same container, unless the generator complies with Section
725.117(b).
B) The generator must not place
hazardous waste in an unwashed container that previously held an incompatible
waste or material (see appendix V of 40 C.F.R. 265, incorporated by reference
in 35 Ill. Adm. Code 720.111, for examples), unless the generator complies with
Section 725.117(b).
C) The generator must separate a
container holding hazardous waste or otherwise protect it by any practical
means from any other incompatible waste or other materials accumulated nearby
in other containers.
4) A container holding hazardous
waste must be closed at all times during accumulation, except at the following
times:
A) When the generator is adding,
removing, or consolidating waste; or
B) When the generator is engaged in
necessary temporary venting of a container for either of the following reasons:
i) For the proper operation of
equipment; or
ii) To prevent dangerous
situations, such as build-up of extreme pressure.
5) A generator must mark or label
its container with the following:
A) The words "Hazardous
Waste"; and
B) An indication of the hazards of
the contents. Examples include, but are not limited to, the applicable
hazardous waste characteristics (i.e., ignitable, corrosive, reactive, or
toxic) listed in Subpart C or D of 35 Ill. Adm. Code 721; hazard communication
consistent with subpart E (Labeling) and subpart F (Placarding) of 49 CFR 172,
incorporated by reference in 35 Ill. Adm. Code 720.111; a hazard statement or
pictogram consistent with 29 CFR 1910.1200 (Hazard Communication), incorporated
by reference in 35 Ill. Adm. Code 720.111; or a chemical hazard label
consistent with NFPA 704, incorporated by reference in 35 Ill. Adm. Code
720.111.
6) A generator who accumulates
either acute hazardous waste listed in 35 Ill. Adm. Code 721.131 or 721.133(e)
or non-acute hazardous waste in excess of the amounts listed in subsection (a)
at or near any point of generation must do the following:
A) Either:
i) Comply within three
consecutive calendar days with the applicable central accumulation area
regulations in Section 722.116(b) or 722.117(a); or
ii) Remove the excess from the satellite
accumulation area within three consecutive calendar days to any of a central
accumulation area operated in accordance with the applicable regulations in
Section 722.116(b) or 722.117(a), an on-site interim status or permitted
treatment, storage, or disposal facility; or an off-site designated facility.
B) During the
three-consecutive-calendar-day period provided by subsection (a)(6)(A)(ii), the
generator must continue to comply with subsections (a)(1) through (a)(5). The
generator must mark or label the containers holding the excess accumulation of
hazardous waste with the date the excess amount began accumulating.
7) All satellite accumulation
areas operated by an SQG must meet the preparedness and prevention regulations
of Section 722.116(b)(8) and emergency procedures at Section 722.116(b)(9).
8) All satellite accumulation
areas operated by an LQG must meet the Preparedness, Prevention and Emergency
Procedures in Subpart M.
b) This subsection (b) corresponds
with 40 CFR 262.115(b), which USEPA has marked "reserved". This
statement maintains structural consistency with the corresponding federal
regulation.