675 IAC 15-1.2-15 Quality control program

Sec. 15. (a) The manufacturer shall develop and implement a quality control program. (b) As part of the quality control program, a quality control manual is required for each manufacturing facility producing industrialized building systems or mobile structures under a design release. The manual shall outline the manufacturer's program for quality control and compliance assurance within each manufacturing facility, including, but not limited to, the following: (1) A location map for the manufacturing facility. (2) A general facility layout diagram indicating the various stations or areas where industrialized buildings or mobile structures are to be produced as well as materials storage areas and office or administration areas. (3) A general description of the in-plant procedures of quality control, including who is performing the quality control and how routine quality control is performed. (4) A general description of what corrective actions are to be taken and who is responsible for the implementation of such corrections. (5) A general description of testing procedures and equipment used to perform test in areas, such as plumbing and electrical, to assure compliance with the released construction documents and the applicable rules of the commission. (6) A sample data plate as described in section 16 of this rule. (7) A statement certifying that an Indiana seal of acceptance issued by the office of the state building commissioner will not be attached to an industrialized building system or mobile structure that does not conform to the applicable rules of the commission. (c) The quality control manual shall be submitted for review and release in accordance with section 3 of this rule. (d) Any revisions to the quality control manual shall be submitted for review and release in accordance with section 11 of this rule. (e) The manufacturer shall implement the released quality control program.