675 IAC 31-4-5 Inspection seal

Sec. 5. (a) A regulated amusement device that, upon inspection by the division, is found to comply with all applicable laws and manufacturers' specifications shall have a seal applied by the inspector. The seal shall serve as the regulated amusement device operating permit as set forth in section 4 of this rule. (b) The regulated amusement device operating permit shall not be obtained from any source other than the division. (c) If an inspection seal becomes mutilated or damaged, a replacement shall be furnished upon written request to the division. (d) If an inspection seal has been applied and the regulated amusement device operating permit is subsequently revoked for noncompliance with applicable laws, the: (1) seal may be removed and destroyed by the representative of the division; and (2) owner shall be notified immediately. If a new regulated amusement device operating permit is required to allow the operation of the device in Indiana, it shall be issued by the division after an inspection by the division that determines that the device is in compliance with all applicable laws, and a new seal may be attached to the device. (e) The order granting or denying the issuance of a seal shall be issued by the division following the requirements of IC 4-21.5-3- 4. If a petition for review is subsequently granted under IC 4-21.5-3-7, the resulting administrative proceeding shall be conducted by the commission.