326 IAC 20-9-1 Applicability; incorporation by reference of federal standards

Sec. 1. (a) This rule establishes emission limitations for operations involved in the manufacture of any flexible base substrate that is covered with a coating containing magnetic particles and that is used for any type of information storage such as audio and video recording. (b) These provisions apply to each new and existing magnetic tape manufacturing operation located at a major source of hazardous air pollutant emissions. Research or laboratory facilities, as defined in 40 CFR 63.702*, are exempt from these emission standards. (c) Applicable operations include, but are not limited to, the following: (1) Solvent storage tanks. (2) Mix preparation equipment. (3) Coating operations. (4) Waste handling devices. (5) Particulate transfer operations. (6) Wash sinks for cleaning removable parts. (7) Cleaning involving the flushing of fixed lines. (8) Wastewater treatment systems. (9) Condenser vents associated with distillation and stripping columns in the solvent recovery area, but not including the vent on a condenser that is used as the add-on air pollution control device. (d) The air pollution control board incorporates by reference 40 CFR 63, Subpart EE, National Emission Standards For Magnetic Tape Manufacturing Operations*. (e) Major sources, as defined in 326 IAC 2-7-1(20), subject to the provisions of this rule are also subject to the requirements of 326 IAC 2-7. *These documents are incorporated by reference. Copies may be obtained from the Government Printing Office, 732 North Capitol Street NW, Washington, D.C. 20401 or are available for review and copying at the Indiana Department of Environmental Management, Office of Air Quality, Tenth Floor, 100 North Senate Avenue, Indianapolis, Indiana 46204.