326 IAC 6.8-2-6 BP Products North America, Inc.-Whiting Refinery

Sec. 6. (a) BP Products North America, Inc.-Whiting Refinery in Lake County, source identification number 00453, shall meet the following emission limits: Emission Limits Source lbs/MMBtu lbs/hr CRU, F-101 feed preheater 0.0075 0.536 Stack serving number 1 CRU, F-102A heater 0.0075 0.447 Stack serving number 1 power station, boiler numbers 5, 6, and 7 0.0075 5.924 Stack serving number 11 pipe still furnaces H-101, H-102, H-103, H-104, coke preheaters 0.0075 1.49 Number 11 pipe still, H-1X heater 0.0075 1.863 Number 11 pipe still, H-2 vacuum heater 0.0075 0.335 Number 11 pipe still, H-200 crude charge 0.0075 1.859 Number 11 pipe still, H-3 vacuum heater 0.0075 0.410 Number 11 pipe still, H-300 furnace 0.0075 1.341 Stack serving number 12 pipe still, H-1AS, H-1AN, and H-1B preheaters and H-2 vacuum heater 0.0075 4.918 Each stack serving number 12 pipe still H-1CN crude preheater 0.0075 0.894 Number 12 pipe still, H-1CX crude preheater 0.0075 3.055 Number 2 isomerization, H-1 feed heater furnace 0.0075 1.416 Each stack serving number 3 power station, boiler numbers 1, 2, 3, 4, and 6 0.0075 4.28 Number 3 ultraformer, F-7 furnace 0.0075 0.171 Number 3 ultraformer, H-1 feed heater furnace 0.0075 1.788 Number 3 ultraformer, H-2 feed heater furnace 0.0075 1.378 Stack serving number 4 ultraformer, F-1 ultrafiner furnace F-8A and F-8B reboilers 0.0075 2.936 Number 4 ultraformer, F-2 preheater furnace 0.0075 2.131 Number 4 ultraformer, F-3 number 1 reheat furnace 0.0075 1.803 Stack serving number 4 ultraformer, F-4 number 2 reheat furnace, F-5 number 3 reheat furnace, and F-6 number 4 reheat furnace 0.0075 2.124 Number 4 ultraformer, F-7 furnace 0.0075 0.387 Aromatics recovery unit, F-200A furnace 0.0075 1.859 Aromatics recovery unit, F-200B furnace 0.0075 1.859 Blending oil desulphurization, F-401 furnace 0.0075 0.261 Each stack serving the cat feed hydrotreating unit F-801 A/B and F-801C 0.0075 0.943 Asphalt F-1 heater 0.0075 0.089 Asphalt F-2 Steiglitz Park residual heater 0.0075 0.209 Sulfur recovery unit incinerator 0.0075 0.285 Beavon Stretford tail gas unit (B/S TGU) 0.0075 0.182 DDU WB-301, DDU WB-302 0.0075 1.106 Hydrogen unit B-501 0.0075 2.729 (b) The F-100 marine docks distillate heater shall have the following emission limits: Emission Limits Source lbs/MMBtu lbs/hr 0.0075 0.052 (c) BP shall comply with the following emission limits: Emission Limits Source Units lbs/hr Wastewater sludge fluid bed incinerator 0.173 lbs/ton based on 79,000 lbs/hr fluidizing air flow 6.84 FCU 500 1.220 lbs/1,000 lbs coke burned 73.20 FCU 600 1.10 lbs/1,000 lbs coke burned 55.00 (d) Emission limits in subsections (a) and (b) apply to the sum of the filterable (front half) and condensible (back half) particulate matter. The total quantity of particulate matter emissions shall be determined in accordance with 40 CFR 51, Appendix M, Method 201A* for determining filterable matter and 40 CFR 51, Appendix M, Method 202* for determining condensibles. However, if a demonstration is made to the commissioner that excessive temperatures preclude the use of 40 CFR 51, Appendix M, Method 201A*, then the commissioner may allow the use of 40 CFR 60, Appendix A, Method 5* for determining filterable matter emissions, to be used in conjunction with 40 CFR 51, Appendix M, Method 202* for determining condensibles. Alternatives to these methods may be used, but only if they are approved in writing by U.S. EPA prior to the test. *These documents are incorporated by reference and are available from the Government Printing Office, 732 North Capitol Avenue NW, Washington, D.C. 20401 or are available for review and copying at the Indiana Department of Environmental Management, Office of Air Quality, Indiana Government Center-North, Tenth Floor, 100 North Senate Avenue, Indianapolis, Indiana 46204.