326 IAC 6-2-1 Applicability

Sec. 1. (a) This rule establishes limitations for sources of indirect heating. (b) Particulate emissions from the combustion of fuel for indirect heating from all facilities located in Lake, Porter, Marion, Boone, Hamilton, Hendricks, Johnson, Morgan, Shelby, and Hancock Counties, which were existing and in operation or which received permit to construct prior to September 21, 1983, shall be limited by section 2 of this rule. (c) Particulate emissions from the combustion of fuel for indirect heating from all facilities not specified in subsection (b), which were existing and in operation or which received permits to construct prior to September 21, 1983, shall be limited by section 3 of this rule. (d) Particulate emissions from the combustion of fuel for indirect heating from all facilities receiving permits to construct on or after September 21, 1983, shall be limited by section 4 of this rule. (e) If any limitation established by this rule is inconsistent with applicable limitations contained in 326 IAC 6.5 and 326 IAC 6.8, then the limitations contained in 326 IAC 6.5 and 326 IAC 6.8 prevail. (f) If any limitation established by this rule is inconsistent with applicable limitations contained in 326 IAC 12 concerning new source performance standards, then the limitations contained in 326 IAC 12 prevail. (g) If any limitation established by this rule is inconsistent with a limitation contained in a facility's construction or operation permit as issued pursuant to 326 IAC 2 concerning permit review regulations, then the limitations contained in the source's current permits prevail. (h) If any limitation established by this rule is inconsistent with a limitation required by 326 IAC 2 concerning permit review regulations, to prevent a violation of the ambient air quality standards set forth in 326 IAC 1-4, then the limitations required by 326 IAC 2 prevail. (i) The addition of a new facility at a source does not affect the limitations of the existing facilities unless such changes in the limitations are required by the provisions of 326 IAC 2, 326 IAC 6.5, or 326 IAC 6.8.