MANUFACTURER'S COMPLIANCE CERTIFICATE

The compliance certificate form furnished by the state building inspector must contain but is not limited to the following information, and must be placed by the manufacturer in the vicinity of the electrical distribution panel or in some other approved designated location that is readily accessible for inspection: A. manufacturer's name and address; B. serial number of the unit; C. model designation and name of manufacturer of major factory-installed appliances; D. where applicable, identification of permissible type of gas for appliances and directions for water and drain connections; E. name and date of standards complied with; F. seal serial number; G. design loads; H. special conditions or limitations of the unit; I. date of manufacture; and J. electrical ratings-instructions and warnings on voltage, phase, size and connections of units, and grounding requirements.