10 CSR 60-6.060
Waivers From Baseline Monitoring Requirements
PURPOSE: This rule establishes waiver
requirements from testing for asbestos,
volatile organic chemicals, synthetic organic
chemicals and inorganic chemicals.
(1) Waivers may be granted by the department
in accordance with the criteria in sections (2)
and (3) of this rule. The department may initiate the evaluation and issue a waiver based
on its evaluation of the criteria in sections (2)
and (3) of this rule. A public water system
may submit a written request and supporting
documentation for a waiver in accordance
with sections (2) and (3) of this rule at any
time if the department has not issued or
denied a waiver.
(2) Use waivers may be granted if it is determined that there has been no previous use of
a contaminant within a given boundary, and
that the public water supply system is in no
danger of contamination from the specified
contaminant. Use waivers are based on the
use, or absence of use, of a potentially harmful contaminant within a given boundary. The
boundary size will be determined by the
department and can range from a single water
system to statewide. Use waivers obtained for
asbestos and synthetic organic chemicals
(SOCs) may relieve the system of any sampling requirements. Use waivers will not be
granted for volatile organic chemicals listed
in 10 CSR 60-4.100(2) or for inorganic
chemicals listed in 10 CSR 60-4.030(1) other
than asbestos.
(A) Asbestos listed in 10 CSR 604.030(1)—Waivers from analysis for asbestos
in a water system will be based on the existence of asbestos-cement piping within the
water system or asbestos contamination within the source water. If any asbestos-cement
piping is present in any part of the treatment/distribution system, or if the source
water is known to or suspected to contain
asbestos, waivers will not be granted.
(B) SOCs listed in 10 CSR 60-4.040—
Waivers from analysis for SOCs in a water
system will be based on knowledge of previous use (including transportation, storage, or
previous disposal) within a given boundary. If
a given SOC has been detected within a water
system, a waiver will not be granted to that
system.
(3) Susceptibility waivers may be granted in
the form of reduced monitoring if all of the
criteria in subsection (3)(A) are met. For
assessing susceptibility and examining criteria
in paragraphs (3)(A)2. and 3., the minimum
boundary area will be a radius of one-quarter
(1/4) of a mile about groundwater well
head(s) or the watershed area(s) of a surface
water source. Susceptibility waivers may be
granted for SOCs listed in 10 CSR 604.040(1) including polychlorinated biphenyls
(PCBs), volatile organic chemicals (VOCs)
listed in 10 CSR 60-4.100(2), and inorganic
chemicals (IOCs) listed in 10 CSR 604.030(1) except for nitrate and nitrite.
(A) Criteria for Susceptibility Waivers.
1. Previous analytical results show no
detections.
2. The proximity of the system to a
potential point or nonpoint source of contamination (that is, Superfund Amendments and
Reauthorization Act (SARA) Title III hazardous waste site) is such that contamination
is unlikely.
3. The environmental persistence of the
contaminant is such that contamination is
unlikely to occur due to the transport time,
geographical, and geological characteristics.
4. The water source is protected from
contamination by being constructed in a manner no less stringent than set forth for nonpublic wells in the Water Well Construction
Code 10 CSR 23-3 promulgated pursuant to
the Missouri Water Well Drillers Act, section
256.600–256.640, RSMo.
5. The nitrate levels have been tested
and it has been found that elevated nitrate levels indicating surface water intrusion do not
exist.
6. The corrosive nature of the source
water and the effectiveness of the systems
corrosion control program.
(B) PCBs—Susceptibility waivers may be
granted for PCBs if the criteria in subsection
(3)(A) are met and there has been no use of
PCBs in the equipment used for production,
storage or distribution of water, or sampling
has not indicated the presence of PCBs.
AUTHORITY: section 640.100, RSMo 2016.*
Original rule filed March 31, 1992, effective
Dec. 3, 1992. Amended: Filed May 4, 1993,
effective Jan. 13, 1994. Amended: Filed June
13, 2018, effective Feb. 28, 2019.
*Original authority: 640.100, RSMo 1939, amended 1978,
1981, 1982, 1988, 1989, 1992, 1993, 1995, 1996, 1998,
1999, 2002, 2006, 2012, 2014.