Information required for equipment

If the facility has equipment to which sections 33.1-24-05-420 through 33.1-24-05-449 applies, the following information must be kept at the facility: 1. For each piece of equipment to which sections 33.1-24-05-420 through 33.1-24-05-449 applies: a. Equipment identification number and hazardous waste management unit identification; b. Approximate locations within the facility (for example, identify the hazardous waste management unit on a facility plot plan); c. Type of equipment (for example, a pump or a pipeline valve); d. Percent by weight of total organics in the hazardous waste stream at the equipment; e. Hazardous waste state at the equipment (for example, gas or vapor, or both, or liquid); and f. Method of compliance with the standard (for example, monthly leak detection and repair, or equipped with dual mechanical seals). 2. For facilities that cannot install a closed-vent system and control device to comply with sections 33.1-24-05-420 through 33.1-24-05-449 on the effective date that the facility becomes subject to sections 33.1-24-05-420 through 33.1-24-05-449 provisions, an implementation schedule as specified in subdivision b of subsection 1 of section 33.1-24-05-403. 3. Documentation that demonstrates compliance with the equipment standards in sections 33.1-24-05-422 and 33.1-24-05-429. This documentation must contain the records required under section 33.1-24-05-434. 4. Documentation to demonstrate compliance with section 33.1-24-05-430 must include the following information: a. A list of all information references and sources used in preparing the documentation. b. Records, including the dates, of each compliance test required by subsection 10 of section 33.1-24-05-403. c. A design analysis, specifications, drawings, schematics, and piping and instrumentation diagrams based on the appropriate sections of "APTI Course 415: Control of Gaseous Emissions" (incorporated by reference in section 33.1-24-01-05) or other engineering texts acceptable to the department that present basic control device design information. The design analysis must address the vent stream characteristics and control device operation parameters as specified in paragraph 3 of subdivision d of subsection 2 of section 33.1-24-05-405. d. A statement signed by the owner or operator and dated certifying that the operating parameters used in the design analysis reasonably represent the conditions that exist when the hazardous waste management unit is operating at the highest load or capacity level reasonable expected to occur. e. A statement signed by the owner or operator and dated certifying that the control device is designed to operate at an efficiency of ninety-five weight percent or greater.