OAR 918-500-7020. Self-Certification and Label Requirements for Voluntary Ignition-Resistant Construction for Manufactured Dwellings

(1) Either the manufacturer within the manufacturing facility or the contractor installing ignition-resistant construction systems on a manufactured dwelling on site shall complete and affix a self-certification label that is verified by quality assurances procedures in accordance with the manufacturer’s policies, and meets all of the following requirements: (a) Either printed on paper or scribed, etched or engraved in metal, plastic or of an equivalent material, with lettering at least 10 point font size; (b) At least 8.5 inches by 11 inches in size; (c) Affixed on a wall or door surface inside the water heater compartment, within the dropped ceiling cavity, or in another permanent and readily accessible location. (d) Positioned in a manner that allows a person to easily access and read the label; (e) Affixed with adhesive or fasteners that discourage the removal of the label; (f) Covered or laminated in a permanent manner with a material that will protect the label from damage or deterioration without obscuring the information; and (g) Clearly identifies which construction standards from OAR 918-500-7010 have been used. (2) A California self-certification label properly installed under Cal. Code Regs. Title 25, Secs. 4200-4216 is recognized as compliant with Section (1) of this rule.