Reglamento General de Seguridad e Higiene Industrial, Cap. VI -- Montacargas de Trabajadores. No incluido en el índice bajo la Ley Núm. 149 de 12 dic, 2005

The rope end shall be pulled as far as possible into the socket SO that the remaining seizing projects outside the hole at the small end of the socket. 7. Position of Socket Preparatory to Pouring Babbitt: The socket shall be held in a vertical position with the large end up, and the rope held in a position truly axial with the socket. Tape or waste may be wound around the rope at the small end of the socket to prevent the babbitt from seeping through, but shall be removed after the metal has cooled. 8. Heating of Babbitt: The babbitt shall be heated to a fluidity just sufficient to char a piece of soft wood such as white pine without igniting it. Care shall be taken not to overheat the babbitt sufficiently to amage the rope. 9. Heating of Socket-Basket and Pouring of Babbitt: The rope socket-basket shall be heated by blowtorch flame sufficiently to prevent chilling of the babbitt and to insure that the babbitt when poured will completely fill the basket including all the spaces between the rope strands. Following this the molten babbitt shall be poured slowly and evenly into the basket until it is filled to a point level with the top of the opening in the large end. 10. Inspection of Socket after Pouring: When the babbitt has cooled and the tape at the small end removed, a visual inspection shall be made which shall show that: - 140 - TEXTO EN ESPAÑOL USAS, A17.1 6. Introducción de las Trenzas Dobladas y