R392-304-7
R392-304-7. Artificial Swimming Lagoon Source Water Quality
Cite as Utah Admin. Code R392-304-7
(1) If the source water for the DSA of an artificial swimming lagoon is not from a public drinking water system as described in Rule R309-100, the operator shall:
(a) collect a sample of the source water before initial operation and at least once every five years thereafter;
(b) submit the collected sample for analysis to a laboratory that is certified under Rule R444-14; and
(c) ensure that the source water complies with the contaminant limits specified in Table 1.
(2) If the source water analysis report described in Subsection (1) indicates that a contaminant level exceeds any standard in Table 1, the operator shall:
(a) discontinue the use of the source water; or
(b) implement treatment to achieve compliance with Table 1 before introducing the water into a designated swimming area.
TABLE 1
Source Water Contaminants and MCLs
Contaminant
Maximum Contaminant Level (MCL)
Antimony
0.006 mg/L
Arsenic
0.010 mg/L
Barium
5 mg/L
Beryllium
0.004 mg/L
Cadmium
0.005 mg/L
Chromium
0.5 mg/L
Copper
2.0 mg/L
Fluoride
8.0 mg/L
Lead
0.015 mg/L
Mercury
0.002 mg/L
Nitrate
50 mg/L
Selenium
0.05 mg/L
Thallium
0.002 mg/L
(3) The operator shall maintain a closed-loop system for water recirculation.
(4) If the water source for the DSA of an artificial swimming lagoon is connected to a public or private potable water source, the operator shall ensure that:
(a) the water source system is protected from a backflow or back-siphonage event with a backflow preventer, such as an air gap, a mechanical backflow prevention device, or another means or method in accordance with Plumbing Code; and
(b) the backflow preventer does not connect to the discharge side of a recirculation pump of an artificial swimming lagoon.
(5) The operator shall:
(a) measure and record the total dissolved solids (TDS) concentration of the filled lagoon water before the initial operation of the DSA to establish the startup baseline TDS concentration;
(b) monitor TDS in each DSA at least annually thereafter; and
(c) ensure that TDS does not increase by more than 1,500 mg/L above the established startup baseline, unless the operator demonstrates to the local health officer that the increased concentration does not impair:
(i) disinfection effectiveness;
(ii) circulation or filtration performance;
(iii) equipment integrity; or
(iv) bather safety.