R9-14-613. Compliance Testing for Waste Parameters

A. A licensee for a laboratory at which compliance testing for waste parameters is performed shall ensure that each waste sample for Arizona compliance testing is analyzed using an approved method: 1. Listed in Table 6.2.C; or 2. Approved by the Department for waste compliance testing under R9-14-610(E). B. A licensee for a laboratory at which compliance testing for waste parameters is performed using an 8000 series method from Key Reference F shall: 1. If the method includes specific quality control requirements, follow the specific quality control requirements in the method; 2. If the method does not include specific quality control requirements, follow all requirements in Key Reference F14; and 3. If the method does not include specific sample extraction procedures, follow the procedures in the following from Key Reference F, as applicable: a. Method 3500B, b. Method 3600C, or c. Method 5000. C. A licensee for a laboratory at which compliance testing for waste parameters is performed using a non-8000 series method from Key Reference F shall comply with the following from Key Reference F, as applicable, according to the requirements of the specific method: 1. Method 4000, or 2. Methods 7000B and 7010. D. A licensee for a laboratory at which compliance testing for waste parameters is performed using a method from Key Reference F shall comply with Chapters 1 through 8 of Update IV, February 2007, of Key Reference F, as applicable, according to the requirements of the specific method.