Water Main Construction Applications

TITLE 35: ENVIRONMENTAL PROTECTION SUBTITLE F: PUBLIC WATER SUPPLIES CHAPTER I: POLLUTION CONTROL BOARD PART 602 PERMITS SECTION 602.260 WATER MAIN CONSTRUCTION APPLICATIONS Section 602.260 Water Main Construction Applications a)         Water main construction permit applications must specify the following: 1)         the existing population served by the present supply, and the population to be served by the water main extension; 2)         the average daily pumpage for the community water supply on an annual basis; 3)         the maximum daily pumpage; 4)         the capacity of the community water supply; 5)         the capacity of the raw water source; 6)         the capacity of the proposed water main; 7)         the normal expected operating pressure on the proposed water main; 8)         the minimum expected operating pressure on the proposed water main; 9)         the pressure at the point of connection at present maximum demand; 10)         the calculated pressure at the point of connection under maximum demand after installation of the water main; 11)         the size of the pipe and total feet of the water main; 12)         the pipe material and type of joint; 13)         the proposed depth below ground surface of the water main; 14)         sewer and water separation: A)        an indication of whether the minimum horizontal and vertical separation requirements in 35 Ill. Adm. Code 604.1440 have been met; and B)        an explanation of other measures taken to protect the water main if the separation requirements are not met; 15)         a disinfection plan that details the chemical to be used, initial disinfectant concentration, final disinfectant concentration and retention time in hours; and 16)         a water sampling plan to meet the requirements of Section 602.310. b)         The following information must be submitted on plans with water main construction permit applications: 1)         the border lines of the municipality, water district or area to be served; 2)         the size, length and identity of proposed water mains and water system structures; 3)         the elevation of water mains where necessary to show proper separation from sewers and the elevation of other water system structures; 4)         the location of existing or proposed streets; 5)         the location of storm, sanitary, combined and house sewers, septic tanks, disposal fields and cesspools; 6)         the location of pipelines and other sources containing hydrocarbons; 7)         the distance between the community water supply structures and the sources of pollution listed in 35 Ill. Adm. Code 604.150(a); 8)         stream crossings with elevations of the stream bed shown, including the normal, extreme high and extreme low water levels of the stream; and 9)         all appurtenances, specific structures or equipment having any connection with planned water mains and water system structures.