35 Ill. Adm. Code 602.305
Operating Permit Applications
Section 602.305 Operating Permit
Applications
a) All applications for operating
permits must be on Agency forms and must contain:
1) the community water supply's
name, address, identification number and project name;
2) the construction permit number,
type of construction permit, and date the construction permit was issued;
3) an explanation of the status of
the construction project. If the project is only partially completed, the
applicant must provide the information set forth in Section 602.320; and
4) any other information required
by the Agency for proper consideration of the permit, including the submission
of the water sample results under Section 602.310.
b) If the operating permit
application is for the operation of a well, the application must include the
following information in addition to the information required by subsection
(a):
1) final
geologic well log;
2) aquifer
property data;
3) lateral area of influence, as
calculated under 35 Ill. Adm. Code 671.Subpart B;
4) delineated wellhead protection
area;
5) pump test data:
A) the latitude and
longitude of the observation well;
B) test pump capacity head characteristics;
C) static water level;
D) depth of pump settings; and
E) time of starting and ending each test cycle;
6) static water level in
the production well and observation wells;
7) pumping water level in
the production well;
8) transmissivity in gallons per day per foot
of drawdown (GPD/ft);
9) hydraulic conductivity
in gallons per day per square feet (GPD/ft
2
) or feet per day
(ft/day);
10) saturated thickness of
the aquifer (ft);
11) storage coefficient or
specific yield (dimensionless);
12) recording
and graphic evaluation of the following, at one-hour intervals or less:
A) pumping rate;
B) pumping water level;
C) drawdown;
D) water recovery rate and
levels; and
E) specific capacity,
measured in gallons per minute per foot (GPM/ft) of drawdown;
13) a
determination of the regional groundwater gradient and flow direction:
A) if the groundwater
gradient and flow direction was estimated, provide the data, and the source of that
data;
B) if the groundwater
gradient and flow direction were not estimated, provide the longitude and
latitude of the wells used, well logs, and the water elevations observed in the
wells during the pump test;
C) provide the compass
direction clockwise from north in degrees; and
D) provide the gradient;
14) geological data:
A) a driller's log
determined from samples collected at 5-foot intervals and each pronounced
change in formation;
B) accurate geographical
location, such as latitude and longitude or GIS coordinates;
C) records of drill hole
diameters and depths;
D) order of size and length
of casing, screens, and liners;
E) grouting depths;
F) formations penetrated;
G) water levels; and
H) location of any blast
charges; and
15) analyses of water samples
for the constituents listed in 35 Ill. Adm. Code 620.410(a) and (b).