Class B(3) Permits to Burn Off-specification Used Oil Fuel Generated at the Site of Burning

In addition to conditions imposed pursuant to 310 CMR 30.202(2), the general conditions set forth in 310 CMR 30.205 and 310 CMR 30.206, and the standards set forth or referred to in 310 CMR 30.253, 30.254, and 30.256, the following conditions shall apply to each Class B(3) permit to burn used oil fuel at the site of generation, regardless of whether or not such conditions are written into the permit. Permittees shall comply with such conditions whether or not they are written into the permit. Failure to comply shall be grounds for an enforcement action, including, without limitation, permit suspension or revocation. (1) The permittee shall not burn any waste oil or other hazardous waste, regardless of where it is generated. Except for used oil fuel approved in the permit by the Department, the permittee shall not burn any used oil fuel or hazardous waste fuel, regardless of where it is generated. (2) The permittee shall not receive from off the site of generation, and shall not contract to receive from off the site of generation, any material described in 310 CMR 30.266(1) as material the permittee is not authorized to burn. If the permittee receives or otherwise comes to possess any such material not generated at the site of burning, the permittee shall immediately so notify the Department and shall manage such material as hazardous waste in compliance with all applicable provisions of 310 CMR 30.000. (3) The permittee shall not mix used oil fuel with any other material unless such mixing is done for the purpose of making fuel which, at the time the mixing occurs, the permittee may lawfully burn pursuant to 310 CMR 7.00 and 310 CMR 30.000. (4) The permittee shall immediately notify the Department of any change in the characteristics, composition, or source of any used oil fuel that would require that the used oil fuel be managed differently, that the conditions of the permit be changed, or that the permit be suspended or revoked. (5) If the permittee is required to use laboratory analysis to determine that used oil fuel is specification used oil fuel, the permittee shall determine that the used oil fuel is specification used oil fuel by causing samples of such fuel to be analyzed only by laboratories certified by the Department or by laboratories meeting standards of quality control and quality assurance acceptable to the Department. (6) The permittee shall at all times be in compliance with 310 CMR 7.00.